Technical Post: 1930's Fingerwaves and Bobs

Products and Tools needed for Hair:

-Small/Narrow Curling Tongs

-Pintail Comb

-Smoothing Brush

-Denman Brush

-Kirby Grips

-Sectioning Clips

-Hairspray

-Shine Spray

-Vitapoint

Instructions:

-Make sure hair is washed and prepped.

-Part hair in a left hand parting in line with the highest point of the brow.

-Section front of the hair from the crown and separate from the back.

- Start curling larger front section (Section 1) in a brick formation, downwards towards the ear, in 1 inch barrel curls and clip to set.

-Curl the smaller front section (Section 2) in 1 inch barrel curls backwards towards the back of the head and clip to set.

-Start curling the back section (section 3) in 2 inch barrel curls, downwards towards the neck, in a brick formation. Clip to set.

-Once all the hair is fully set, brush out each section using your smoothing brush. Use a small amount of Vitapoint to define waves, and allow hair to sit in the direction it was set in.

-Roll the bottom section of the hair up and secure into bob using Kirby grips.

-Apply hairspray to set, and shine spray to front section to add shine.